HomePatrol-1 Firmware Update 2.05.03
(1 viewing) (1) Guest

TOPIC: HomePatrol-1 Firmware Update 2.05.03

HomePatrol-1 Firmware Update 2.05.03 19 May 2014 23:50 #13818

  • KevinC
  • ( Moderator )
  • OFFLINE
  • Moderator
  • Posts: 31
  • Karma: 1
Addresses the following issues:

Improves ATTEN status indication (#1 issue for returned units is ATTEN is activated).
Improves GPS status indication.
Fixes the "Conventional Discovery Mode" bug (hangs on P25 control channel during discovery).
Improves P25 performance.
Adds warning to WX Standby splash screen if standby is entered while ATTEN is on.
Last Edit: 19 May 2014 23:51 by KevinC.

Re: HomePatrol-1 Firmware Update 2.05.03 20 May 2014 04:43 #13823

  • BradD
  • ( User )
  • OFFLINE
  • Fresh Boarder
  • Posts: 4
  • Karma: 0
when will it be available?

Re: HomePatrol-1 Firmware Update 2.05.03 20 May 2014 05:20 #13826

  • Jay911
  • ( User )
  • OFFLINE
  • Gold Boarder
  • Posts: 175
  • Karma: 5
It's already available. Hook your HP1 up to your computer and press Update Firmware inside Sentinel.

Re: HomePatrol-1 Firmware Update 2.05.03 20 May 2014 05:45 #13827

  • BradD
  • ( User )
  • OFFLINE
  • Fresh Boarder
  • Posts: 4
  • Karma: 0
yes, it is now. It wasn't very early today when I updated HPDB and check software/firmware versions. Updated just fine now. Thanks!

Is Sentinel version 2.02 revision 04 from January 7, 2012 the most recent Sentinel version?

Thanks!
Last Edit: 20 May 2014 05:54 by BradD.

Re: HomePatrol-1 Firmware Update 2.05.03 20 May 2014 19:55 #13829

  • Elton
  • ( User )
  • OFFLINE
  • Gold Boarder
  • Posts: 166
  • Karma: -1002
Firmware upgrade worked perfectly.... 5/20/14 @ 3:55 P.M.

Re: HomePatrol-1 Firmware Update 2.05.03 21 May 2014 18:11 #13839

  • Ohio-user
  • ( User )
  • OFFLINE
  • Platinum Boarder
  • Posts: 494
  • Karma: 1
Posted on RR

1: All analog conventional channels now have a 200ms to 300ms squelch tail.

I do not see this.

2: Monitoring the MARCS APCO an active talk group now hangs 4+ seconds after transmission before releasing back to control channel. Once the radio releases the voice channel there's a loud "pop".

I do not get the "POP, but the 4 sec hang time is an issue. I also manually set some for 0 delay and it still experiences a 4 sec delay.



3: If the system is busy and another group uses the voice channel before the radio releases holding voice channel, the display will show the the previous group the radio hung on but audio is from another group.

Can verify this also - not sure if it also reflects on recordings.

4: Monitoring the MARCS-IP P25 yields no audio improvement.

Agree.

I have 2 side by side so will be doing comparisons with and without - so far I see no improvement and some severe issues.
Time to create page: 0.18 seconds